I want to make sure I get it right this time. If you want to connect the AirPort Extreme to the Internet, purchase a Cat5 ethernet cable and use it to connect the. There’s no on/off switch - it turns on when you plug it in. What should I set for Internet settings (connect via DHCP?, what about IPV6?)Īlso, is there a certain ordering sequence that the config should be performed? I burned the whole weekend trying to get my original configuration to work. Here’s how to set up an AirPort Extreme Base Station: Unbox the AirPort Extreme and plug it in. Configure Network > Router mode to 'Off / Bridge mode' What else am I missing? Do I need to do anything with DMZ Plus, etc? Connect an Ethernet cable from LAN interface to LAN interface on AE Any suggestions on the steps to configure this way? Would this be the correct configuration on both devices to try? I want to go back and re-try the originally attempted configuration where the AE is simply a passthru and provides the wireless connectivity in the home and everything whether wired or not is on the same network. This normally wouldnt be a big deal, but now I have some devices wired (I have Ethernet drops in each room of the house that go to a Gigabit switch in the garage) on one network and some wireless on another and now things like Sonos, Plex, and potentially other services are not able to connect. The 192.168.1.x wired network that is served by the 5268 when I plug things in via Ethernet and a 10.0.1.x wireless network when devices connect wirelessly. The only issue I have is I now have effectively two networks. The problem was that the AirPort line paled in comparison to other routers on the market. Apple’s AirPort Extreme, AirPort Express, and AirPort Time Capsule products were never bad Wi-Fi routersthey had sufficient speed and connectivity, so they worked well in most householdsbut they never stood out. Connectivity is now solid for both Ethernet and wireless and speed is awesome. The simple answer to this question is no. Enter a check mark in the box next to 5 GHz network name. Click the Wireless Options button near the bottom of the window. Click the Wireless tab at the top of the next window. Click Edit in the smaller window that appears. I enabled DHCP + NAT on the AE, disabled wireless on the 5268 and used the DMZ Plus mode on the 5268 to allow traffic to the AE. Open AirPort Utility (Finder > Applications > Utilities > AirPort Utility) Click on the picture of the AirPort Extreme. I finally resorted to cabling from the WAN interface on the AE to the LAN interface on the 5268. I could get Ethernet via the 5268 to work, but could not get the AE wireless to stay up and allow endpoints to connect. I tried this past weekend to get that to work with no success. The goal is to create a single network whether connectivity is via Ethernet or wireless. I want to configure the AE in bridge mode and use the AE wireless and disable the wireless on the 5268, but let it do DHCP. I recently signed up for U-Verse Gigapower and have the Pace 5268AC gateway.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |